Lumber, roof, span and fastener tables

Lumber, Plywood and Framing

These pages cover the sizing questions that come up before you buy or cut framing lumber: how many board feet a pile of boards is, what a 2x4 really measures, how thick a sheet of plywood actually is, what weight to expect, how hard a species is on the Janka scale, what thickness of drywall a wall or ceiling needs, what a brick measures, and how many studs or joists a wall or floor needs at a given spacing. Nominal sizes and actual sizes differ, so each page shows the dressed dimensions from the published standard. Spacing pages only count and mark layouts; how far a member may span is a code and engineering question, covered on the span pages with the assumptions stated.

Tools in this group

  • 2x4 Dimensions — A 2x4 is really 1-1/2 x 3-1/2 in (38 x 89 mm); choose another nominal size or dry/green to see its actual dimensions in inches, feet, mm and cm.
  • Board Foot Calculator — Enter the thickness, width, length and number of pieces to get board feet, plus cubic feet, cubic meters and cost if you type a price per board foot.
  • Brick Dimensions — Pick a brick type and joint size to see its specified and nominal size in inches and mm, its coursing and how many brick cover 100 sq ft, then add a wall area for a brick count.
  • Drywall Thickness for Walls and Ceilings — Choose a wall, ceiling or garage ceiling, the framing spacing and the finish to see the minimum drywall thickness in inches and mm, the fastener spacing and what each thickness is for.
  • Floor Joist Spacing — Enter the length your joists are spaced across and pick a spacing to get the joist count, the layout marks and where the edges of a 4 x 8 sheet fall.
  • Janka Hardness Scale — Pick a wood to see its Janka hardness in lbf, kN and kgf, its rank among 167 species and how it compares with northern red oak or a second wood.
  • Lumber Dimensions — Choose a nominal size such as 2x6 to see its actual dimensions in inches and mm, dry or green, with its area, section modulus and moment of inertia.
  • Lumber Weight Calculator — Choose a species, nominal size, length and number of pieces to get the weight in pounds and kilograms, dry or green, or type your own density.
  • Plywood Sizes — Pick a panel size to see its dimensions in inches and millimeters, then enter a room or area to get the number of sheets and an approximate weight.
  • Plywood Thickness Chart — Choose the thickness on the panel label to see the decimal inches, the millimeters and the tolerance band, with the real stamped thickness one maker prints.
  • Stud Spacing Calculator — Enter the wall length and the spacing to get the stud count and a table of tape marks measured from one end, starting at 15 1/4 in for 16 in on center.